|
Tidy up your builds with these 3PDT boards!
This version of the 3PDT-board has space for a bypass LED and a Current Limiting Resistor. The space from the center of the 3PDT switch to the LED is 16mm. Remember that the board as shown here ends up upside down when looking at the pedal, so the LED hole should be to the left of the 3PDT hole (as shown in the third picture). Note that this also has a "LED" pad so you can use it on any project that has the LED+CLR mounted on the main board aswell. In that case just ignore the LED and CLR on the 3PDT board. On the other hand, if the main board doesn't have a board-mounted LED/CLR then ignore the "led" connection pad. |
Recommended for these projects:
For other projects check out the barebone version 3PDT board |